RAW_PRINT
8K MSLA-printed in photopolymer resin. Supports cleaned by hand. Subtle layer lines remain — they prime out.
++++REFERENCE_ONLY
Supplied unpainted and unassembled. All painted images on this page are operator builds, for reference only — your kit ships raw.
++++EDITION_OF_250
Numbered first edition of 250 units. WSV-05 will not be re-run — once the run is claimed the design is retired to the archive.
++++OPERATOR_CARD
Each kit ships with a 65 × 65 mm numbered operator card featuring your avatar on the back. Card is tied to your reservation.
++++SHIPPING
Free Australia-wide shipping via Sendle. International (NZ, US / CA, UK / EU, Asia, RoW) at cost-plus via DHL Express. See /legal/shipping for tier rates.
++++EARLY_BIRD
First 50 reservations lock in at A$99. Standard A$109 once the early-bird slots close. No re-runs after the 250-edition is claimed.
++++
Verify part count against included manifest sheet. Inspect for shipping damage. Photograph any defects within 7 days for replacement.
++++Light sanding of pre-clipped support nubs. Warm soapy bath to remove release agents. Pat dry; air-cure 30 min before priming.
++++Dry-fit all sub-assemblies before glue. Resin tolerances are tight — check for warp, gentle heat-correct if needed. Mask seam lines you intend to fill.
++++Cyanoacrylate on all permanent joints. Articulation pegs are friction-fit — do not glue. Allow 24h full cure before primer.
++++
++++DethKlaw Miniatures
Greece-based independent digital sculptor working in small-scale sci-fi mechs and robot characters. Hard-edged industrial designs with visible engineering — exposed cabling, mechanical joints, armour that looks load-bearing rather than smoothed-over for shelf appeal.
Releases pre-supported STL files designed to print clean on standard MSLA hardware. Each kit ships with Lychee scene files and tested support orientations — production-quality at the file level, not just the design.
WSV-05 is the first Mini Mecha collaboration. The bipedal Walker chassis was iterated across eleven test prints before final master release — part separation, support orientation, and assembly tolerance all worked through end-to-end.