Light Mapping: Zenithal Priming for Deep-Recess Resin

A two-pass priming method to map shadow geometry before color goes down. Black-on-black recovery without rework.

A walk through the WSV-05 print cell. Print runs, wash-and-cure cycles, and where every block gets its serial.

Odorless mineral spirits vs. zippo fluid vs. dedicated enamel thinner. We ran a 24-hour bleed test on each.

STL format requirements, scale guidance, and what we mean by 'print-ready'. Read before you submit.

Non-metallic metal scales differently than people think. Where it pays off, and where you should just paint metal.

Layered weathering doesn't mean piling effects. A protocol for picking three signals and committing to them.

We tested four spray-and-strip methods on photopolymer resin. One works on every kit we tried; one almost ate the surface.

Shipping windows, customs guidance for EU/JP/AU, and the full part-by-part inventory for builders to verify on receipt.

Where to clip, where to file, where to leave layer lines alone. A part-by-part walkthrough on a WSV-05 sprue.